how to connect using wps button with macbook

When the printer has successfully made a connection to your wireless network, the Power and Wi-Fi lamps will stop flashing and remain lit.ĥ. The blue Wi-Fi lamp on the printer will continue to ﬂash while searching, and the Power and Wi-Fi lamps will both flash when connecting to the access point. Then then go to your access point and press the button within 2 minutes.Ĥ. Press button (C) and then the button (A) make sure the Wi-Fi lamp (D) flashes quickly and the ON lamp is lit as shown in illustration below.

Press and hold the button (A) on the printer until the ON lamp (B) flashes.ģ. Make sure that the printer is turned on and the WPS button on the wireless router is accessible to be pressed when required.Ģ. Please follow the steps below to complete the setup -ġ. For details on which security method is being used on your wireless network, please check the wireless connection settings on your computer. Most WPS enabled access points will not connect using the WPS method if the WEP (Wired Equivalent Privacy) security method is used, or if no security is enabled. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. The access point must have a physical WPS push button available, please check with your device’s user guide for details.

Before we start, there are however some conditions that must be met in order to use the WPS push button method:

How to connect using wps button with macbook